Introducing Technical Drawing - Manual and Digital is a resource that targets both teachers and students.
Target Audience: VCD Teachers
Part 1 - Manual Technical drawing
Part 1 viewing time is approxmately 60 mins
Manual Technical Drawing introduces teachers to the basics of using instruments to produce technical drawings.
This part includes 5 filmed demonstrations to instruct the VCD teacher on how to construct Orthogonal, Isometric, Planometric, One Point and Two Point perspective drawings.
Ideally, you will learn the skills via the demonstrations and teach your students. However, it is also possible to share these films with students if you are working remotely or a student is absent and working from home.
Target Audience: VCD Students and Teachers
Part 2 - Digital Technical drawing
Part 2 viewing time is approxmately 60 mins
Digital Technical Drawing is a series of 5 recordings that demonstrate how to re-draw your manual technical drawings using Adobe Illustrator. Ideally, the students will draw manually and then scan and trace/re-draw their drawings using Illustrator. A good level of skills with Illustrator is required for this part.
The recordings demonstrate how to use a range of Illustrator tools to construct Orthogonal, Isometric, Planometric, One Point and Two Point perspective drawings.
View a sample from both series:
This resource is only available for purchase by VCV members
Cost of the Resource - $175 Members only
